Side cut out jig, saw guide

In stock
Stock Code
TC1279-483A
A$128.91 Incl. GST
favorite Add to Wish List

The Cut Out Jig is used to quickly and neatly prepare the side of a new duct length, to make a cut out for quickly installing a drop-off or a break-out guide (ie an outlet trumpet). The jig is centrally located about a centre mark on the top of the duct edge. It is clamped in position, and two quick cuts are made using a hand saw (Part No: 100 x 060 – available separately) to the full depth of the marked slots for the item to be installed. Next a Stanley knife is run (two or three times) along the bottom of the jigs straight edge, between saw cuts, to make a straight longitudinal cut in the ducts side. The Cut Out Jig is unclamped and removed from the duct, and the prepared piece of duct is removed using light finger pressure. The Stanley knife is used to clean the ducts edges, and the nominated item is quickly and simply fitted into the prepared cut out. The Cut Out Jig is used for:

Duct Size Item

50mm x 50mm TC1279-93A
100mm x 50mm TC1279-232A
100mm x 100mm TC1279-218A
220mm x 100mm TC1279-330A
300mm x 100mm TC1279-379A

Note: Also used for making cut outs for TC1279-452A and TC1279-454A
Note: that a slot for Part No: TC1279-93A can also be used with Part No’s: TC1279-41KIT and TC1279-89, on all duct sizes.

  • Enables new duct sides to be quickly and easily prepared for fitting drop-offs or break-out guides (outlet trumpets) 
  • Purchase as a unit 

Write Your Own Review

Only registered users can write reviews. Please Sign in or create an account

Looking for optic fibre and copper communications equipment?

Contact us