This guide is used where pigtails and patch - cords are routed around 90° corners. It is a simple means of providing a 30mm radius guide that eliminates fibre stress through bending. The guide is basically a curved surface with a clip at one end that enables it to be clipped to any flat surface (of thickness between 1.6 and 3.0mm). It can also be clipped into itself, both length and sideways, to extend the guide angle or increase the surface area available.
Simple clip system attaches to flat steel and plastic duct (1.6 to 3.0mm thick).
Interlocks lengthways to extend (through multiples) of 90°.
Interlocks sideways to extend surface area and accommodate large numbers of cords (See Figure 3 in the Product Guide).